Search results

Hi all, Last weekend was a blast! We did about 100km of mixed riding. Sand trails, gravel roads, beach, rocks, tar and farmlands. The trip was from darling, western cape, to grotto bay. Here are some pix.

Has anybody thought of or done a conversion from the stock suspension ball joints to adjustable rose joints? I am thinking of fabing such a setup, or even making a new set of arms, with rose joints instead. The idea is to make the suspension setup fully adjustable. .. Any comments or advice...

I just curious if anyone had a reed petal screw come loose and ingested? When I assembled my engine, I noticed there were some recesses where the screw heads should be, but never bothered checking what clerences there are. My quesion is, if a screw would come loose, will it fall out and get...

Hi all, After splitting my motor, and waiting for my seals, I notice that my balance shaft was knocking on the casing (I am aware of the factory machined clearence, but there was extra material missing and was knocking when rotated...) Apon closer inspection, the front bearing had close to 1mm...

After splitting cases to repair leak between cranc case and gearbox, I noticed that one of the ring locating pins are missing on the piston, it seems to have made its way out the exhaust port. My question is, would it be ok to run the motor with the missing pin, or could it cause the ring to...

Hi all, Hope you doing well. I went for some fun at a MX track the weekend. The first real performance test for my blaster. I did notice my tranny oil getting used up rather quickly, and smoking a wee bit too much. So, i recon right side crank seal, right? Pulled that out, and the bush looked...

Here, goes, my new baby just got delivered this morning, already striped it all down, and cleaning up. Not sure whats all done to the motor, but the owner says it wheelied in 6th.. Checked the carb and it has a 310 main, so that gives me the idea of some mods, probably porting too. Notice the...