Recent content by uniquebrett

ok thank you that is helpful

I saw on this forum that you can shut off your oil injection pump by removing a outside e clip and removing a roll pin can you be more specific as to what is required to complete this transition to premixing your fuel?

I saw on this forum that you left your oil injection pump on your blaster and just capped off the ends of your oil lines...is that correct? Have you had any problems doing this? I am switching my blaster over to a premix type so I will not depend on the oil injection system.

I am in the the process of starting to reassemble this blaster motor...When I tore it down, some of the piston skirt was broken off. I got some pieces but it is impossible to determine if all pieces are accounted for. Is it possible to take the engine/transmission out of the frame and...

ok thanks for the replies fellas...I am still undecided what I will do, but will put something on the back.

I doubt if you guys have seen it, but I am considering welding up a small rack or carrying type bar to bolt in place of the chrome handle on the rear end of the blaster. Has any one done this or have seen any on a blaster...I got this for the kids, but it is handy for farm work....any...

ok that sounds good thank you for the very quick reply. the piston is in awful shape and now I am going to check for a service of reboring the jug any suggestions? Brett

how do I remove the wrist pin in the piston...I removed one clip on the end of the wrist pin. Can I drive the pin out with a hammer and punch??? Before on other motorcycles the wrist pin slides in and out easily once the c clip is removed from the end of the wrist pin.....this wrist pin is in...

Well I knew I would be around younger people....but I am just doing this to teach my kid how to drive with a hand clutch......just kidding! I am 37 and my boy is 11 and I have a girl that is 9....they love this blaster. This is my 1st post......take care guys and I enjoy all the stuff you...