Recent content by sheeblast

those quad are light and do make power. next mod should be a shower for it and get some more pictures.

XCR are 6ply and have the sideways outside thread. this gives them more grip when turning and the 6ply offers better resistances to tire puncture. normal holeshots are 4ply. the XCR are better but they also cost more.

never had a problem with any of the polarises that i have rode. neither has the person that own some that i help work on. they are run great and have no problems. you base your judgement over a company off one problem.

off one quad you are going to say that? i would put up the scrambler frame to a blaster, oh wait i seen what happened when a blaster hit a scrambler, the blaster frame twisted. i have seen polarises run for a long time without any problems. it all comes down to the owner. i knew someone...

it might have caused the problems, yes.

but the answer isn't that simple, depending on the year of his blaster, you can not just flip the rims. reason i said search. all this info is on the site and there are lots of pictures of people doing it.

search the forum, you will find your answer.

you should still do a leakdown test, you most likely blew the seal.

leak down test is super easy, also that is called the needle, the clip should be around the middle, but second from top would make it leaner. try putting it in the middle notch.

^^^ why do people say that? have you owned one? do you know the problems with them? or are you going off what others say?

do a leak down test to see if you have an air leak.

you need a seal kit, something like this Moose Racing Oil Seal Set - Cheap Cycle Parts you most likely have a blown clutch side oil seal that is letting both air and tranny fluid into the crank case. the air will cause the hard starting and high idle, the fluid will cause the smoke.

air leak or lean jetting. you said blue smoke? might have a bad seal.

i will take $30 shipped for it

no f*cking idea. i am just selling one mount that didn't work for my set up because i already have a fat bar stem and this needs to mount to a stock stem.