Recent content by jokerfacewild

Will anyone sell me a leakdown tester. I've been to four stores and cannot find all of the correct parts to build one.

Okay so I found my leak. Carb boot was split. Up and running now. When i pulled off the old boot though i noticed the little wingg inside was cut off. Anyone have an idea why someone would do that? Stock reeds. NOw on a completely Different subject my rear chain guide is missing. Getting a...

In need of the rear axle please. Email me a way to get in contact. Jokerfacewild92@gmail.com

Okay so no air. Im doing my countersprocket seal as it is leaking. The large bolt on the bottom of the block would be the drain plug im assuming?

Thanks mate. I can't wait for my book so I don't have these stupid questions

How to adjust it. Its way too tight. It was a lot easier to do on my yz

Okay so im in the process of cleaning the carb now and removing the tors and I think I found where some air could be leaking. On the left side of my engine the electrical wires where they go into the case cover thw the rubber gromet is not set in. Would that cause the leak?

Okay so I definitely know this is a dumb question but where is the tensioner to loosen my chain? Does anyone have a pic? I've tried the downloadable service books but can't get them on my phone. I do have one ordered though

Can I look for a leak while its running just by spraying the soapy water on it?

So should I jet higher fuel then? Ive been gettin mixed answrrs going through old threads

I apologize. It was just going at full rev my throttle leaver came bqck out though. Still at full throttle

Anyone have a reat axle to get rid of? Mines slightly bent. Could that do damage?

Will remove tors in the morning. Link for getting a tester? Or can I do it without buying a tool? But why would the throttle stick wide open?

Okay it is bored .40over. Im going to clean my carb tomorrow and start my 32-1 I checked the kill anf it was okay. Overheated like hell. How do I take care of this leaning? I picked up a 240 250 260 main jet today whrre to start. I would like to remove airbox lid. What would that do? Mods...

Okay picked up my 2002 blaster today and there is a little bit of a project. Gotta do the seal behond the countersprocket. It has a little side to side play and th e seal is leaking. Seal ordered and seems easy but is there supposed to be that play? Gotta order all of the chain rollera and all...