Recent content by GANKS

What rear light is that? I hate the stock Blaster light, it's huge, that looks great!

Will it fit a Blaster and how much?

Long story short, I was in the process of threading my Mikuni carb for an idle screw and the thread tap (or die, what ever teh cutting tool is) broke inside of my carb with part of the tool remaining stuck in the carb. I could try to drill it out slowly and hope the threads work for the idle...

Hi, I have an impact driver and a corded impact driver drill. I cannot seem to break the stator screws loose to remove them. Any secrets to getting those buggers out? I have begun to strip out the top one so I'm a little paranoid about ruining them to the point where I'd have to cut them...

After doing a little more research and having my mechanic buddy take a quick peek at it, it looks like the seals are shot and the engine is pulling in oil from the crank case. I bought new seals for both side of the case. Does anyone have a good video on replacing the crank seals on the...

Sounds good, I'll get some ATF to flush it and use some gas at the end to absorb the moisture. I'm doing a carb rebuild and oil delete this week also. Once I put it all back together I'll compression test it and leak down test it to see if it's tight. The oil drain screw bolt was stripped...

Hi, I just picked up a 2005 Blaster for $300 off FB last week. I got it running (badly) shortly after picking it up and decided to do some common maintenance on it to get it running better and see how much work and time this project will cost me. Last night I changed the oil and out spilled...