I'm goin have to run race gas to break in my motor I only plan to get 2 gallons of gas So my question is wat the breakdown on how much oil I should And also wat kind of oil
As for ratio, start off thick and move thinner as you get out of the "idling period" Mix the first gallon like 25:1 and then after that move up towards 32:1. Worked great for me!
I'm not sure I agree with this quote though. Changing the oil/fuel mix also changes your air/fuel ratio. 25:1 would cause you to run richer, I think, but still my gut says break it in like you are going to use it.
Yes indeed .With that said, I agree, break in with the same ratio you intend to run afterwards.
with the mods listed in my sig im only pushing around 160psi and i dont need race gas. so unless you are more modded you are just wasting your money.
I dont remember what the PSI was on my CT 240 after break in but I dont think it was much higher then 160 psi, I might be wrong.
I hope I did not F it up
CT recommended a 50/50 mix of race gas and pump gas and 32:1 break in then 40:1 after the 1st tank of gas
Now I want to do a compression check.X( Anyone know what my psi should be?
I just got my new tank on to and now its time to take it off.X(
just to throw my 2 pennies in here my manual for my yz 250 says break the engine in at 15:1 and then move up
i belive mr 305 said his psi was around 180 or 190 and hes got a ct kit.