quick clutch problem

[CRAZYKID16]

ok i just put in a new shift drum an rode my quad for a lil bit an now the cltuch will now ingage what cold my problem be could someone help me

 

[Awk08]

here we go again, lucky im just copy and pastin this............... it took me 4 or 5 times to get this right, very frustrating, do all this with the cable disconnected at the hand lever so it doesnt effect the internal adjustment, open her up, again!!!, loosen the locknut and screw, back it out a little, (the adjustment shaft in the middle of the clutch basket) then where the cable connects to the motor lever,theres a notch that lines up, look on the engine lever for the little point and a mark on the case, line these up, make sure it doesnt move while adjusting, a freind would be good here, then move to the other side, tighten the rod in with a small straight screwdriver till you feel it touch, then i think i read somewhere to back it off 1/2 a turn,then tighten the locknut, <<<<definately use locktite here, mine almost came loose, and thats disaster, then reconnect the cable to the hand lever, and adjust your slack i also did this with the wheels off the ground, so i could spin them with the clutch lever pulled in,to see if the wheels spun free, or if there was engine lag as i released it, before i put the cover back on
hope this helps

 

[CRAZYKID16]

thanks alot ill try that an let u no how it goes