I'm looking for tips, tricks, ideas on how to put an entire engine together starting at all the pieces cleaned and laying out on the table. I have the Clymer's manual, a box of assorted C Clips, full (hopefully) gasket set, O-ring set, and some kind of sealant Napa told me would be good for putting the case together.
We tore the case apart trying to find out why the shifter won't work but found nothing wrong, even after rolling the rods on glass to see if they were out of whack. We finished wire brushing all the parts and are ready to put it back together. I've been reading a bunch of threads on this and that but was hoping for a concentrated thread on just putting it back together.
Thanks all ahead of time!!
We tore the case apart trying to find out why the shifter won't work but found nothing wrong, even after rolling the rods on glass to see if they were out of whack. We finished wire brushing all the parts and are ready to put it back together. I've been reading a bunch of threads on this and that but was hoping for a concentrated thread on just putting it back together.
Thanks all ahead of time!!