i blocked off the oil. i live in florida so there isnt really any elevation. what should size jets should i use first?
i put the little nipple cap on the carb, but you thing it is an air leak? where would it be i did put vforce 3 reeds on also and removed the tors could any of that be causing the problem
Sounds like a leak down test is needed, if anything is done concerning the inlet there is a problem that leaks will occur.
Don't bump the main jet up, that will make it too rich, you have already richened it by switching to 32:1.
Do a leak down test to diagnose the problem before you mess with anything.
i didn't put a ziptie on the nipple ill go do that but i did put all new gaskets on and used gasket maker to seal it off, and for the tors i removed it and put the top cap on, and drilled and tapped the idle screw.
Sounds like a leak down test is needed, if anything is done concerning the inlet there is a problem that leaks will occur.
Don't bump the main jet up, that will make it too rich, you have already richened it by switching to 32:1.
Do a leak down test to diagnose the problem before you mess with anything.