Ok guys here it goes. Im new to the forum but not to atv's or small engines. I am currently putting together a blaster for my wife. I literally got the thing in boxes full of pieces. I currently have the whole chassis and engine together and started to wire it yesterday. I have everything hooked up, the ICU, voltage regulator, CDI unit, headlight, coil and the magneto. the only things that are not hooked up are the Tail light, oil injection light and sensor(i eliminated the oil inj setup), Tors unit(no longer on the bike) so the throttle and carb switch are not hooked up. My problem is that I still have no spark. I have double, triple checked everything and I cannot seem to figure out why there is no spark. Im wondering if the coil and or the stator wires are malfunctioning. I am currently going off the specs from the service manual that I got off of the forum. Does anyone have the specs for testing the coil for ohms? or maybe even a better wiring diagram or some pictures of wiring the bike. I would really appreciate it. Any advice would help. I will get pictures up as soon as I can. Thanks everyone