mud runners rebuild

[mud runner]

here it is

 

[mud runner]

before

after

i think i did a pretty good job on it

 

[mud runner]

what do yall think about me porting the reed cage

 

[blasterBruce]

what do yall think about me porting the reed cage

the reed cage does not need any work to be honest , get a head mod , that's a Noticeable mod !

 

[mud runner]

the reed cage does not need any work to be honest , get a head mod , that's a Noticeable mod !

maby this winter but im trying to get it put toghter so i can finish raceing this season

 

[blasterBruce]

That Diy port work looks pretty good , not too much taken off

 

[mud runner]

do you think i need to take more off

 

[blasterBruce]

NO , Leave it how it is until you run it !

 

[mud runner]

ok i was thinking that it was pretty good how it is but wanted some more oppinions on it

 

[blasterBruce]

You will get more advice and reviews for it

 

[Blaaster]

Not bad, but look at it this way any edge will create turbulence and can act as a wall.

Smooth out the edges where there are angles and make them rounded.

Do not finely polish the intake, leave it a little matt to help stop fuel beading.

 

[mud runner]

Not bad, but look at it this way any edge will create turbulence and can act as a wall.

Smooth out the edges where there are angles and make them rounded.

Do not finely polish the intake, leave it a little matt to help stop fuel beading.

i will do that tonight

 

[mud runner]

this is the crank i think im gonna buy WISECO BOTTOM END REBUILD KIT GASKETS SEALS 1987-06 YFS 200 BLASTER CRANKSHAFT | eBay

 

[scotj77]

that'll work for ya..

 

[mud runner]

well we are going tomorrow morning to get my new bottom end and gonna buy some parts tomorrow and i got the telescoping gagues out and made sure the ports were both the same size and its a good thing i did because one was bigger than the other

 

[blasterBruce]

what was bigger than the other ?

 

[mud runner]

one of
the 2 ports 15151515151515

 

[blasterBruce]

thats common without a proper port map or a template to work with

 

[mud runner]

well im trying to get them as close as possible

 

[blasterBruce]

Understandable , do your best to go by look and feel for peaks and valleys