intake boot?
- Thread starter readytorip24
- Start date
yes it will,
and will also split eventually causing a massive airleak and fry your piston.
get the correct intake for the 34/35 carb.
UPP and Moose both sale them on ebay for under $60
that beats $250 for a top end rebuild
Last edited:
Yes, but no.
Like awk said.
And when you want to do a rebuild, its never what you think it will cost.... I figured $350 tops on mine. I added so much that its closer to $600...
Like awk said.
And when you want to do a rebuild, its never what you think it will cost.... I figured $350 tops on mine. I added so much that its closer to $600...
Damnn you must have did a rebuild and some upgrading ! I got my Wiseco complete top and bottom end kit for like $315 shipped ... But then of course I had to buy a case splitter, crank puller/installer, fly wheel puller, impact gun, and pay to have the jug bored and honed. I was right at the $600 mark by the time it was all said and done as well haha.
Straight answer is NO it wont fit. I wouldnt try squeezing anything more than 30mm on there, and thats tight.
My 28mm fits well on the stock boot, but for a 35 Id definitely go bigger.
My 28mm fits well on the stock boot, but for a 35 Id definitely go bigger.
