Idling Help...

[Blaster30]

I've just finished rebuilding my complete motor and have done heat sessions but for some reason i just can't figure out how to get it idling by itself without me having to touch the throttleto keep it running i don't even know where the idle screw is....pretty sure the air screw isn't it but what is and where do i find it... PUT TORS BOX BACK ON

 

[brandoz28]

does it still have the TORS box on it?

 

[Blaaster]

Float level must be set first then,

Idle adjusting.

Start with air screw 1.5 turns out.

Set idle screw so that it has some sort of idle. With TORS big screw under seat on top of unit. No TORS brass screw midway down carb body.

Warm up motor and then set idle screw for a faster idle, 2000rpm+

Adjust air screw either way to get the fastest idle.

Adjust air screw a little at a time leaving 10 secs to allow the motor to respond.

Re adjust idle screw for desired idle .

 

[Blaster30]

so i should let it warm up first right then mess withe idle screws and let the choke all the way in while doing it

 

[Hillbilly_Proud]

so i should let it warm up first right then mess withe idle screws and let the choke all the way in while doing it

yes warm with choke off, or in all the way

 

[Blaaster]

The float level must be set correctly as it controls the amount of fuel available and the pickup height of the fuel for all carby settings.

The motor must be at operating temp wiith the choke off before touching any screw.