Help! , I bought a new blaster and when I stop it shuts down on me
- Thread starter Jakerz
- Start date
Could it be your idle?? Turn it up a litte.
Tell us every mod on the blaster, is TORs removed?
The chain tighteners on the back of the axle carrier, you need to tighten those. If they are in all the way, pull them out and take a link out of your chain.
http://www.blasterforum.com/engine-13/best-way-newbies-get-their-problems-solved-please-read-55590/
Tell us every mod on the blaster, is TORs removed?
The chain tighteners on the back of the axle carrier, you need to tighten those. If they are in all the way, pull them out and take a link out of your chain.
http://www.blasterforum.com/engine-13/best-way-newbies-get-their-problems-solved-please-read-55590/
You need to loosen the 2 nuts/bolts on your carrier before adjusting the chain tensioners or you'll just strip them out !
Chain should 30 to 40mm slack with rider sitting on bike.
Idle adjusting.
Start with air screw 1.5 turns out.
Set idle screw so that it has some sort of idle. With TORS it is the big screw under seat on top of unit. With no TORS is is the brass screw midway down carb body.
Warm up motor and then set idle screw for a faster idle, 2000rpm+
Adjust air screw either way to get the fastest idle.
Adjust air screw a little at a time leaving 10 secs or until the motor to responds.
Re adjust idle screw for desired idle .
Idle adjusting.
Start with air screw 1.5 turns out.
Set idle screw so that it has some sort of idle. With TORS it is the big screw under seat on top of unit. With no TORS is is the brass screw midway down carb body.
Warm up motor and then set idle screw for a faster idle, 2000rpm+
Adjust air screw either way to get the fastest idle.
Adjust air screw a little at a time leaving 10 secs or until the motor to responds.
Re adjust idle screw for desired idle .
