So previous owners were idiots but when I built this motor the rear most stud pulled out of the cylinder when being torqued. I helicoiled the hole and it held. It has been ridden about 5 to 10 hours since then. Well this past weekend we went out to ride and at the end of the day I blew the headgasket in the exact spot that the stud is at and the stud is starting to pull out again.
Idk if it is pulling out when it gets hot and has pressure on it or what but I need to fix it.
Any ideas on how to fix the head stud?
Idk if it is pulling out when it gets hot and has pressure on it or what but I need to fix it.
Any ideas on how to fix the head stud?