Ok so far i have gone through the entire wiring harness and deleted all the wires not needed. this is a 98 blaster not mine. what i have left is
key switch- black to cdi and black/white wires hooked into line with the rest of the black/white wires
Handel bar switch- on/run black ground and black/white wires
yellow/red wire to stator with tied in blue wire to voltage regulator
yellow and green wire to headlight with black ground
Ground wires are grounded at the front of the quad and at the coil with freshly cleaned mounting points and checked for continuity.
cdi box is hooked up color coordinated to the stator and coil and black wire to the main key switch
stator ohms out within specs
all wires checked for continuity and visually inspected for rubbed spots
coil and cap have been ohm'd out and are within specs also.
I have changed the cdi out with a working cdi. still nothing.
any input?????
I have also switched out plugs, flywheels voltage regulators with known working ones to no avail
key switch- black to cdi and black/white wires hooked into line with the rest of the black/white wires
Handel bar switch- on/run black ground and black/white wires
yellow/red wire to stator with tied in blue wire to voltage regulator
yellow and green wire to headlight with black ground
Ground wires are grounded at the front of the quad and at the coil with freshly cleaned mounting points and checked for continuity.
cdi box is hooked up color coordinated to the stator and coil and black wire to the main key switch
stator ohms out within specs
all wires checked for continuity and visually inspected for rubbed spots
coil and cap have been ohm'd out and are within specs also.
I have changed the cdi out with a working cdi. still nothing.
any input?????
I have also switched out plugs, flywheels voltage regulators with known working ones to no avail