Chrome
- Thread starter nightmare420
- Start date
so far only gave him the handlebars. ne ideas on what will need to be done to swinger and a-arms before they can be dipped?
idk get the a arms bumper handle bars swinger thumb throttle carrier shock spring headlight bracket kicker shifter and may be even the head?
yes i know, but once again, what will need to be done to the grease fitting and everything else on the swinger and a-arms?
you would ave to pull all bearings, ball joints(if removable), grease fittings, chain guides. most likely sand blast them to bare metal. as far as a arms if they are stock with non removable balljoints, i wouldnt do them. you would be looking for new ones soon after. the 300-400 degree wash/salt baths will pull all the grease and may ruin the plastic in the ball joints. besides you would get chrome inside the joint to and cause premature wear on it.
Sorry its been a while guys. The a arms are stock so i figured it wouldnt be possible. Rear rims are itp aluminum so ill leave them. But im goig to see if he will do the front rims, headlight bracket, zink on the foot pegs an kicker prolly, and the thumb throttle and anything else little that wont take much maintinence in the future. Gotthe handbars back last week they look fantastic!! Pics in a bit! I need mounting ideas now i dont want to get them all scratched when bolting em down
http://http://i189.photobucket.com/albums/z147/nightmare0098/2e842b91.jpg[/IMG
]
And this ones just to show its still sh*tty inside and not full. So not much extra weight
[IMG]http://http://i189.photobucket.com/albums/z147/nightmare0098/3977beb8.jpg
Last edited by a moderator:
