i do need a leak down tester. i would like to test it before i disassemble the engine. I would have like to have it apart by now but the only place i have to work on it is under my porch...and its to dang cold for that
Another newbie in PA
- Thread starter smuckerpud
- Start date
Thanx guys. And I'll hit you guys up when I go up. My top end is honed, ported and polished. New wiseco top end kit and wiseco crank kit en-route.
Thanx guys. And I'll hit you guys up when I go up. My top end is honed, ported and polished. New wiseco top end kit and wiseco crank kit en-route.
Got everything together and broken in. Went to the coalhills on Sat. Had a blast. The biotch rips pretty well. Couple more pics attached.
if you call the DCNR up and give them the vin they can run it over the phone for you. pretty much they'll tell you if it was ever registered in Pa.
So, finally took the swingarm off to give to my buddy to extend. Was just gonna do that... yeah, not so much. Ended up getting 400ex rear shock and stock banshee fronts, full set of bearings (wheels,swing,carrier), CFM alum airbox w/uni pod filter, complete hydro upgrade (raped my buddys banshee roller(and making him mount the rear)) new clutch cable, lever, perch, new oring chain.
all in all, cost me about 375. I like to think i made out.
Plus i got DCNR to release the title, and have it coming in my name.
all in all, cost me about 375. I like to think i made out.
Plus i got DCNR to release the title, and have it coming in my name.
Did my swingarm last night. Probably still going to have to move the chain guide mount. Extended it 5.25". I'll do the mockup tonight to find out where it needs to go, then sand and paint it after its moved.
