35mm carb to airbox adapter

[sandblaster240]

Anyone have any suggestions for adapting a 35mm PWK to the stock airbox?

 

[1997blaster]

some people cut the are tube where it gets bigger then hose clamp a pipe that about the same size as your carb the get a rubber fitting that will go frome that pipe to your carb a lowes or somewhere i think that will be your best bet or you can but an aftermarket air box

 

[specialized7]

sure do
instead of the trenga tube use pvc pipe and cut some rubber off

then grab a 2 1/2" rubber adapter from any home building center

put it all together using metal band clamps

in order to fit the 35mm into the stock intake manifold you have to dremal it out.

you will see in the pics above i have to cut up an extra reedcage to make reedspacer so the clutch arm wouldnt hit the carb.
i also bent the clutch arm down a bit.

 

[1997blaster]

sure do
instead of the trenga tube use pvc pipe and cut some rubber off

then grab a 2 1/2" rubber adapter from any home building center

put it all together using metal band clamps

in order to fit the 35mm into the stock intake manifold you have to dremal it out.

you will see in the pics above i have to cut up an extra reedcage to make reedspacer so the clutch arm wouldnt hit the carb.
i also bent the clutch arm down a bit.

thanks i was trying to frind that thread

 

[specialized7]

haha ya you can find it in my sig

 

[1997blaster]

lol i saw the thread on the home page after you posted that

 

[sandblaster240]

Thanks a lot for the fast responses! It's much appreciated.