Search results

Ok so I got the new carb and put it on it'll run for about 5 seconds put then I pull the plug and it's soaked tried 3 brand new plugs I'm thinking the stator is bad and ideas

That's the way it usually is but they are getting strict on the older and smaller bikes the don't even look at my 2015 yfz just sign and pay see you at the finish lol

Yeah motorcrossed one a while back that's what I wanna do with this one but I can't seem to get it race worthy still gotta get an axle though it's bent a little bit. It not noticeable but won't pass inspection

Thing was junk when I bought it Ive seen nicer in the junk yard but I wanted a project and completely redone the bike just wish the carb wasn't junk so I can ride it

Nooo not a eBay rebuild put in a wiseco bottom end with a pro-x piston kit, cometic gaskets, lightened flywheel

Yeah I ordered a mikuni carb it'll be in next week

Yeah I ordered a mikuni carb it'll be in next week

Here's after I got it all painted before I dropped the motor in %5BURL=http://s350.photobucket.com/user/John_Stephen_Kiggins/media/IMG_4275_zpsvjec2dlh.jpg.html%5D%5BIMG%5Dhttp://i350.photobucket.com/albums/q425/John_Stephen_Kiggins/IMG_4275_zpsvjec2dlh.jpg%5B/IMG%5D%5B/URL%5D

See what the bike or carb

I'm ordering a mikuni it has a cheap carb on it now

I'm ordering a new carb it's not a factory carb or mikuni it's a cheapo from eBay

Both it was leaking on the crank seal where that bushing went in and what would cause it to wind up when I let off the throttle the key wouldn't turn it off and thank you

What is the float height supposed to be and how do I adjust and check it

Ok I went through checked all the seals and got a new spark plug it'll run now but won't idle for very long and kinda bogs when I punch the throttle any ideas I mean it's rideable but the bogging is annoying

What's the gear slide and no I didn't but it has all new seals and bearings

I just rebuilt my blaster today top and bottom end new crank, bearings, seals, piston, and jug at first it wouldn't start now it'll run for a few seconds then die and it's putting out white smoke but have to kick the guys out of it to get it to start getting good spark brand new reeds any ideas

its never had a bottom end done so im gonna tear it down and build it up custom

I know the compression isn't good the guy I bought it from done an ebay rebuild and didn't hone the cylinder I can roll it over by hand and I just put v force reeds on it I know the reeds are good and I pre mix my oil

So I bought a 01 blaster I couldn't get it to start cleaned the carb and played with it for a little bit got it to run so I figured I would ride it around the yard make sure everything was ok got about 100 yards then it died now when I kick it it squeaks it wont start and run. it will fire then...