i have a 2006 blaster the guy i got it from said that the oil injector didnt work right or something along them lines he said i had to use mixed gas is this ok or should i look into why it dont work right if its ok to just use mixed gas what should i use and what ratio shoullld i use
gas problem
- Thread starter Chaddydaddy
- Start date
I would look into why it not running and if it is still hooked up. See if he removed the oil pump or the oil lines.
http://www.blasterforum.com/threads/how-to-remove-oil-injection-without-a-block-off-kit.3272/
http://www.blasterforum.com/threads/how-to-install-oil-injection-block-off-kit.681/
http://www.blasterforum.com/threads/how-to-remove-oil-injection-without-a-block-off-kit.3272/
http://www.blasterforum.com/threads/how-to-install-oil-injection-block-off-kit.681/
before i found out i had to mix the gas i put oil in it and it poored out of a line so i asked him about it and thats when he said it didnt work and i needed to mix gas he said that was how it was when he got it
Pre-mix 32:1
Has the carb got the oil tube going down to the side of the engine, Rear brake lever side.
Has the carb got the oil tube going down to the side of the engine, Rear brake lever side.
the re is a line under the hadlebars by the gas tank that when i put oil in it it poored out of looks like its been cut at somepoint
The tube up the front at handle bars near take is a crankcase vent.
Looks like the oil injector is still all attached.
Go to this page. And scroll down to my photos. Remove that cove and see if the oil pump is still in there. 4 Bolts hold cover on. Done worry there is no oil in this area.
http://www.blasterforum.com/threads/how-to-install-oil-injection-block-off-kit.681/page-5
Looks like the oil injector is still all attached.
Go to this page. And scroll down to my photos. Remove that cove and see if the oil pump is still in there. 4 Bolts hold cover on. Done worry there is no oil in this area.
http://www.blasterforum.com/threads/how-to-install-oil-injection-block-off-kit.681/page-5
