Recent content by rotalley

Looking at the pictures and reading thru the DIY sticky again it appears the conversion is correct. Reeds are good, fuel flows from bowl when drain screw is opened, and air filter is clean. But I dont have a spark to a new spark plug. Thanks for your help Blaaster and Awk08

I cut and spliced the wire on the ecu side of the plug on the wire that went to the thumb throttle and did the same on the wires that went to the carb. Both splices were yellow wire with black stripe to a black wire. That is exactly what the DIY demonstrated. Also installed the new throttle...

It's only started about 3 times in a week of trying. It won't stay running with throttle applied. It dies like the fire is killed. This quad has always started on first or second kick. Theres more to it than the idle adjustment, I believe there's still an electrical component that's not right...

I have a 2003 blaster and recently had tors problems and after much searching I found this site. I bought the tors removal kit with carb cap, throttle cable, and idle adjustment screw. I followed the sticky in this forum exactly as described cutting off plugs under hood for thumb throttle and...