Recent content by rivera82

Thanks guys, got them at ACE they are .20 cents a piece, they looked at me strange when i paid with my debit card .22 cents hahahaha

So i need a clutch ball bearing and i found one at my local hardware store its a chrome one will that suffice?? same size 3/16 what about hardness? will it last? Thanks for the advice

Thanks Thanks, but im still not allowed to post in the market place.

Hi im looking for some parts please let me know if you have them and how much.

well i found out the issue to my bad compression, i went from 140 psi to 190 psi with a new top end, but I'm still smoking like a chimney and going thru fuel like there's no tomorrow, 2 gallons in 1 1/2 hrs, my slow jet is a 50, it wont idle and the smoke is thick and lingers, compared to my...

The thing about this forum is that it has bigger support. And most of the guys here know there 2 stroke.

Sorry if it came out wrong, sarcasm does not translate well in text, maybe a hahaha at the end? Hahaha

Seams like a good deal.....to you, but i think ill keep this one for several years. Well over at trx250r.net im supposed to have anywhere from 160 to 185 psi

That makes sense, ill replace the top end and see how it does

ok, so i took my R out past Saturday and after riding a bit i ran out of fuel, pushed it home and poured close to 2 gallons after riding for about 1 1/2 hrs i ran out of fuel, what can be the cause for that much fuel consumption? or is it normal for the R? my main jet is a 152, my needle is a...

1. will a LTR450 rear shock fit a blaster? 2. what would be needed is it shorter or longer? 3. will it improve ride? 4. would the bushing from kenoconnor work? 5. will it raise or lower the blaster? Thanks Guys.

Ill go ahead and contact sicivicdude, thanks for all the replies.

Thanks I did not know the name of that part. I do not have a tig welder, I put an ad on Craigslist to see if anybody answer. Any questions I should ask the person that would weld it? To test and see if I should trust him with my case. The penny is for reference, I put the same pictures...

I just bought my second blaster, and it has a part that broken, right on the kick start, will welding it work?? is the case aluminum or a magnesium alloy? here are some pics

I'll add this one: next to the sheriffs station on Montana past Joe Battle Hwy, looks like at one point they were digging up rock and sand, 10 square miles??, its big anyways, a lot of hills and packed dirt 31°49'26.59"N 106°15'54.41"W