Recent content by Perdueracing

Iv got a stock bore new top end carbon pro reeds no lid toomey b1 pipe

Anyone run a pwk 28 mm im wanting to buy a new carb and just wondering how they run compared to the stock carb jetted

Yea iv tried how they ssid but

Yes i the floats are set and iv plug choped and set the idle the 4th clip is a little rich but on the 3rd clip if i rolled into it ran great but coming out of a corner and if i just punched it it would bog so if i run the 3rd clip i have to run a little fat on the pilot jet and airscrew if im...

I had been having trouble with getting my stock bore blaster with pro carbon reeds and no lid and toomey b1 the 310 main works great but the bottom end was bad so this is what i ended up with so far and it rips runs better then any setup on any blaster iv had 35 pilot needle clip 4th from top...

I ended up running a 290 with the needle on 3rd position no lid uni filter still no bottom but that's the best I could get it with stock needle and carb I might get a lrd needle or a Duncan they make there own but anyways the blaster runs the best out of all 3 I've had you just have to stay on...

YeA no air leaks rich on 310 tried a 290 looks pretty good. Picked up some hp on top a little but the bottom is the same I think it's just the pipe I might try a pro circuit or another fmf because my fmf did fine on midrange but not quite the same power as the Toomey and the jetting was different

Ok thanks I'm checking the plug now and maybe trying a 290 and plug chop it

I've got a blaster 66mm piston new cylinder all new gaskets new intake manifold new boysen carbon fiber pro reeds no air box lid foam filter Toomey b1 pipe running 32:1 castor 927 100octane 310 main needle stock position tried 3rd to rich stock pilot air screw right at. Three quarters out...