Recent content by jahrastapark

very nice how you cut those. such a better design than using the flat stock. would you be interested in sending me a template? i dont dig the diamond plate

what is considered cheap? ive got some old AC ones. they need new nets, which is like 10-15 bucks a set.

ive got a set of pro taper SE's

Brand new Motion Pro throttle cable for carb WITH a TORS. It was only installed on the bike for fitment. Freshly Tri-Flow'ed and ready to go. $15 shipped.

fag151515151515151515151

ya really...ive asked for one numerous times...so much for our loyal leader!

ship my axle carrier!

might just be the reason down the line, that you get to some more practice rebuilding topends. itll last for a little while, anyway.

d-slide carb? post pics

"I deserve these reeds because..." anyone who posted before and after me is undeserving.

Those 18's WILL suck. Guaranteed. Get some 20's with a nice heavily treaded pattern. The razr2's have a nice blocky pattern to them but too many untreaded bald spots where glass and sharp sticks and sh*t can puncture.

I have some leftover parts. If you dont see it, just ask. I might have it laying around. Stock swingarm(sh*tted up skid plate comes with) - 30 + shipping Stock clutch perch with parking brake gizmo 5 + shipping Clutch cable - 5 + shipping. Stock steering stem - 20 + shipping. Stok intake...

no its really not that bad at all...if you know what your doing it shouldnt take more than 20 minutes.

do those renthanols run on ethanol?

Well, is it stamped OKO?