Recent content by David madison

I go full throttle then it sounds like it's bogging so I let off and roll back on the throttle then it takes off but every time I shift it seems to have the same issue. Seemed if I rolled on the throttle it would bog real bad then due unless I let off all the way unless I gave it a tiny bit of gas

I can't make any sense of this plug chop.... I tried to go full throttle but almost each time something seemed to hold back.

Blaster Yes it is I mean 250 just did it with the 250 it seemed to hesitate before the chop I was using a br8es I don't know if that matters but for the chop I used b8es

I didn't do a leak test. I did check reeds and goo fuel flow and I checked float level. The air screw is out about 2 1/2 I put a 150 in and dropped the needle one place seems to run better I think enough to do a plug chop. I had to put the airbox back on seems to do better. I'm going to run a...

Finished the heat cycles. But no matter what main jet I put in when I get some speed and go full throttle it bogs until I let off the throttle. It doesn't even seem like a I can do a plug chop because it wont go full throttle

Do you think a dynoport will fit with a fmf turbinecore 2?

Finally got the fmf pipes on. Man was it a battle to get them on probably took me 3 or 4 hours some of the mounts needed to be modified. Everything was put back together and she started right up! I only got to do one heat cycle because it was getting late. I'll get to finish the rest on...

Thank you for the help. Got the head back the other day. I Haven't gotten a chance to put it on because it was raining all day. I did however buy my wife a blaster yesterday and she's pretty excited to ride. Just gotta fix her up probably needs the crank seals. My fmf exhaust system is not...

Thank you. Gives me a good place to start. I need to break in the top end before I do any plug chops right?

Hey everyone I'm new to the forum but I've been reading through the forums for the past few days. I've got a 2001 blaster that was stock when I bought it. I've been adding modification's but need a starting point for my carb. I just replaced all the seals as it was smoking real bad. The new...