Hey guys. Been using this forum for a little while now on my first total rebuild from the ground up on a 01’. Just wanted to say thanks for all the help! So my issue is, I feel the inside part of my balancer gear spun while I was tightening it. Is this possible? While holding gears with a penny I tightened the nut on balancer gear trying to achieve torque and it felt like the inside of that gear spun while the teeth stayed where they were. Ultimately throwing off the timing. (Although the dots still line up) Has anyone had this happen? Doesn’t seem like a great design if that gear is made up of more than one piece. (I.e the middle of the gear is separate from the entire gear) does this make sense? Thanks for any input.