So i didn't see anything on this, figured i'd post it up here.
Mounting Tires By Hand *Not responsible if you hurt yourself*
This thread is to hopefully save some money when things are tight or just for the do it yourselfer that likes to learn new things.
I started off with 2 brand new razr mx 20x6x10 front tires.
Grease up the side you are pressing on the rim so that is will slide on easier. Make sure the direction of rotation will end up the correct way NOW before going any further to prevent further headaches for yourself.
Once you get the first lip of the tire on the rim it should look like this.
Then you will want to start working the outside of the tire and pushing it on the rim like so.
At this point you will need a pair of screw drivers or tire irons what ever you have and you will need to spread the outside bead of the tire on the rim. You will then need to move your knees around the outside to keep the tire down until you get the whole tire over the rim.
Once you get all the way around the rim it should look like this.
Next you will want to get a ratchet strap and put it around the tire in the center to distribute the load.
With the ratchet strap around the tire you will need to hook up an air compressor to the tire and air it up to set beads. You may need to do a little coaxing to get the tire to pop on its bead like spraying grease on the tire or something like that.
CAUTION!!!! DO NOT KEEP YOUR FINGERS NEXT TO THE BEAD WHILE AIRING IT UP!! It will take your fingers off when the bead seats.
Your end result should look like so.
You should now double check pressure in the tire, as it may take several pounds too many to seat beads.
Mounting Tires By Hand *Not responsible if you hurt yourself*
This thread is to hopefully save some money when things are tight or just for the do it yourselfer that likes to learn new things.
I started off with 2 brand new razr mx 20x6x10 front tires.
Grease up the side you are pressing on the rim so that is will slide on easier. Make sure the direction of rotation will end up the correct way NOW before going any further to prevent further headaches for yourself.
Once you get the first lip of the tire on the rim it should look like this.
Then you will want to start working the outside of the tire and pushing it on the rim like so.
At this point you will need a pair of screw drivers or tire irons what ever you have and you will need to spread the outside bead of the tire on the rim. You will then need to move your knees around the outside to keep the tire down until you get the whole tire over the rim.
Once you get all the way around the rim it should look like this.
Next you will want to get a ratchet strap and put it around the tire in the center to distribute the load.
With the ratchet strap around the tire you will need to hook up an air compressor to the tire and air it up to set beads. You may need to do a little coaxing to get the tire to pop on its bead like spraying grease on the tire or something like that.
CAUTION!!!! DO NOT KEEP YOUR FINGERS NEXT TO THE BEAD WHILE AIRING IT UP!! It will take your fingers off when the bead seats.
Your end result should look like so.
You should now double check pressure in the tire, as it may take several pounds too many to seat beads.
