Yfz450 front end on blaster

Tk96

New Member
Oct 18, 2021
2
0
17
27
Just here to show off my blaster build I just started. I'm planning on it being a full on build, yz250 motor, extended swing arm(probably +4), and a banshee rear axle(still need to figure out length needed)

Ok well I put on 2+ inch yfz arms(it's wider than a stock 450), shocks, and tierods on my blaster with only a little costume work.

The only hard thing was tie rods but I only need to put both tie rod ends upside down.
 

Attachments

  • Screenshot_20211018-201200_Snapchat.jpg
    Screenshot_20211018-201200_Snapchat.jpg
    1.2 MB · Views: 210
  • Screenshot_20211018-201228_Snapchat.jpg
    Screenshot_20211018-201228_Snapchat.jpg
    1.4 MB · Views: 237
  • Screenshot_20211018-201244_Snapchat.jpg
    Screenshot_20211018-201244_Snapchat.jpg
    821.9 KB · Views: 236
that looks like you got too much travel and its gonna hit the frame when you bottom out and toss you if you land