Wont shift into gear after full rebuild. First time completing full rebuild.
- Thread starter Ckblaster
- Start date
Yes, I have oileed everything oiled up. I will be putting case halves together too. Is there anything that I have to line up correctly, Like clutch plates or clutch.
Make sure shift star is turned so it clears case when assembling case halves. Time primary gear and balance shaft gear by linning up dots. If the steel plates for your clutch have. A little tab. The steels will be installed with the tabs 60 degrees apart. Basically firts at 12 o'clock 2,4,6,8,10 ect in clockwise
Great job on your rebuild. Now it's time to
Enjoy it. You should do some plug chops to confirm jetting. It's very important to have jetting correct. If it runs lean you will be doing another rebuild
. Got any picsOf it completed.
What do you mean when you say "plug chops"? And yes I will upload some pictures.Great job on your rebuild. Now it's time to
Enjoy it. You should do some plug chops to confirm jetting. It's very important to have jetting correct. If it runs lean you will be doing another rebuild
Of it completed.
You cut. Just the treaded area. Of the spark plug off to get a look at the White insulater.
.look up plug chops on the forum.
