Upper A-arm bushings

[BLASTER 02]

I was riding yesterday and Heard a minor clunking in the front when i went over bumps... I checked them out and both upper A-arms have play by the mounting tabs... Should i just buy oem replacement bushings or get the pivot works A-arm kit that converts to needle bearings??


Thanks!

 

[blasterdemon7]

I would go with the pivot works if you have the money.

 

[slickerthanyou]

Let me save ya some cash, I just ordered the needle bearings and going to reuse my steel sleeves and caps as they are in good condition, cost of four bearings shipped 19.44 sure beats the $80 kit!

 

[slickerthanyou]

Those delrins don't last very long on the rough stuff I ride and piviot works bearings are lifetime guarenteed!

 

[slickerthanyou]

Quick link to what ya need-
WrenchRabbit, Buy Motorcycle Parts Online, Hot Cams, Hot Rods, Pivot Works, Vertex, Cylinder Works

part number-Part #: Y-FCBE-003

 

[BLASTER 02]

Ok thanks slick will make sure the sleeves and caps are good then will buy... Thanks for savin me some$$

 

[BLASTER 02]

Wrench rabBit sent me the wrong parts... They sent. 4 caps and seals instead of the bearings which i ordered... They said keep the caps and sent me the bearings... Great customer service would recommend.

 

[Larry's Shee]

Be sure to coat the bolts with antiseize or at least grease so they don't stick to inside of sleeves.

 

[BLASTER 02]

Be sure to coat the bolts with antiseize or at least grease so they don't stick to inside of sleeves.

Yup i lube all parts that move lol