does anybody know a good source for ytm200 tri moto plastics?some low life disposed of my tank surround that was in my shed while I was rebuilding the engine
tri moto 200
- Thread starter harley1-5
- Start date
Last edited by a moderator:
Worked on a couple back in the day. Way simple to work on even know it ain't a f**king tractor.
my buddy had one, made the mistake of leaving it at my garage,
long story short...
my 200x had a flat, rode the yami, it was a wheelie king, except i didn't know the back drum brakes didn't work after going thru water.
wheelied up a hill, no brakes at the top sent me right off a 20'+ cliff, i flew thru the air so long i had time to think about the landing.
you cannot turn the wheel and make that turn when you land.
put the front forks under the engine and bent the frame.
next days phone call.....
A- i got good news and bad news, which would you like first
R- gimme the good news ?
A- i survived.
R- bad news ?
A- your bike didn't
R- WTF, i'll be down
i replaced all mangled parts within a week for about $250
Similar threads
