I have had this Pro Design shifter sitting around for a bit and decided to see if it fit the blaster. slapped her on and it fit nicely other than the locking bolt wouldn't catch the bottom threaded section. Not sure why, (rust/grime maybe) but I grabbed the round rat tail file and did 2 swipes on the shift shaft with it(back side) and it bolted on nicely. It is for a crf/xr50 and 1/2 longer than stock for them.. Like this one. http://www.ebay.com/itm/NEW-Pro-Des...508-/171702951274?hash=item27fa4b1d6a&vxp=mtr The pic in the link shows it curved but this one is strait ish. I will measure the length and snap a quick pic of it installed once my phone charges..