possible jetting issue

Blasterfan9182

New Member
Mar 20, 2019
7
0
22
41
I have a 2004 Blaster that I recently put a new weisco top end in. Its just not running right. No power, does not hit the powerband, its like i push the throttle and nothing. Its kind of poppy too. Seems like the jetting is off. I have a 360 main jet. Not sure on the pilot, I just set it to what the jet kit said (dynojet). New coil, plug, wire, reeds, carb rebuild, just about everything tope end wise. Running with no airbox lid. I also added 3 more teeth to rear sprocket. It should rip but need to get the jetting right. Any help would be appreciated!
 
Without an aftermerket pipe or airfilter ? oil injection deleted ?
put the stock jets and needle back in it. jetting kits suck !

*32.5 pilot
*airscrew tuned for highest idle between 1/2 and 2 turns out
*stock needle on middle clip setting
*genuine Mikuni 230 main jet if no mods, 240/250 for that airbox lid off
plug chop to confirm

reeds good ? no chips, cracks, hanging open ?
 
B&M exhaust and pipe. Looks like aftermarket filter with no lid on air box.
Oil injection is deleted. 50:1 mix. Reeds are brand new.