plastics

[liminlime_2005]

can u get rid of stress marks (i think u call it) out of plastics?

 

[MINIGfather]

Yes you can...go to the DIY section...There is a thread about the steps on how to do it...

 

[liminlime_2005]

Yes you can...go to the DIY section...There is a thread about the steps on how to do it...

ahh sweet. thanks dude

 

[Blasterdude27]

Its easy but be careful. you can sand it too much or leave the heat gun on there too long. I have learned the hard way...

 

[liminlime_2005]

Its easy but be careful. you can sand it too much or leave the heat gun on there too long. I have learned the hard way...

should i sand it while heating it? fell me in bro!

 

[Blasterdude27]

should i sand it while heating it? fell me in bro!

nnnnnooooooo. lol

That would be terrible! if you need to sand your plastics, sand before you heat them. If you don't have scratches don't sand. Make sure you use a heat gun not a torch. Its pretty straight forward you only learn by doing.

 

[liminlime_2005]

nnnnnooooooo. lol

That would be terrible! if you need to sand your plastics, sand before you heat them. If you don't have scratches don't sand. Make sure you use a heat gun not a torch. Its pretty straight forward you only learn by doing.

oh lol. i was wanderin.

 

[liminlime_2005]

well the scratches arnt to bad but i guess it could use some sanding tho.

 

[Blasterdude27]

Just use like 500 grit or higher, if you use sand paper thats too grainy you can scratch it up worse.

 

[liminlime_2005]

Just use like 500 grit or higher, if you use sand paper thats too grainy you can scratch it up worse.

ok cool. i will have to wait to do it because i wanna bomb my frame then install the engine on it then do the plastics and rms.

 

[mr_3_0_5]

i have a set for sale if you mess em up..lol