Options for air box / intake

[turbowrenchhead]

I bought a keihin 35mm air striker. It has a 58mm O.D. inlet. I would like to utilize my air box since I do go through some deep stuff once in a while and I don't think a uni filter would cut it. I can foresee it going underwater in the future if I just stick a uni on it.

 

[sicivicdude]

So purchase/make an aftermarket airbox OR cut the stock "elephant trunk" tube back far enough that you can get a 2 1/2" tube inside it and then use a rubber connector on the carburetor end.

Utilizing the stock airbox isn't quite as desirable as having one which is "high flow" the whole way but would keep mud and crud out of your engine.

 

[blasterdemon7]

I used a CFM air box but you may be able to come up with something using parts from this place that awk posted before.
Tuning Venair USA

 

[turbowrenchhead]

I ordered a K&N 57mm. I'm sure I can get it on the carb for now till I fab up something to utilize the air box. I'm pretty handy. I bet I can fab something with pvc in side the stock boot and then stick the k&n on the end of it. Is the air box lid a huge restriction?

 

[Whitty21]

dont get fancy with it, you dont want to create something that is gunna result in a bunch of turbulance

 

[Awk08]

thanx for the props dakota, but heres the site i use for silicon adapters.........

Intake Pipe Reducer

 

[blasterdemon7]

My bad .

 

[Awk08]

no, your good, great advice and you found another source for these !!!!!!!!

 

[blasterdemon7]

Awk said I did good!!!