Oil Injection Question

Discussion in 'General Support' started by Harrison, Nov 8, 2021.

  1. Harrison

    Harrison New Member

    Joined:
    Nov 7, 2021
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    7
    Gender:
    Male
    I recently purchased a Yamaha Blaster. The blaster still has the factory oil injection system and is running mixed gas. I filled the reservoir with yamalube 2 cycle oil and disconnected the oil line from the carb. I fired up the quad with the line disconnected. I watched a drop of oil come out of the line about every 10-15 seconds while the quad was at idle speed. Is this a normal amount of oil at idle speed?
     
  2. Awk08

    Awk08 Administrator Staff Member Technician

    Joined:
    Jan 30, 2009
    Messages:
    24,416
    Likes Received:
    2,279
    Trophy Points:
    175
    Occupation:
    Electrician/Contractor
    Location:
    Pa.
    you can't run both injection and mix, it would have to be running like poo and probably fouling plugs ?
    and you also cannot run it with the line off the carb, unless you blocked it off ? it was a severe air leak.
    you're this far, just delete the injectionm block off the nippple on the carb with an 1/8" vacuum cap, and keep mixing it 32:1 with a good oil designed for air cooled 2 strokes ....
    Yamalube or Maxima Super M injection formula
     
  3. Deets

    Deets Member

    Joined:
    Nov 28, 2020
    Messages:
    55
    Likes Received:
    10
    Trophy Points:
    44
    Gender:
    Male
    Just make sure the oil you choose is for premix. Injection oil doesn’t stay in suspension as long.
     
    Awk08 likes this.

Share This Page