New to this

Discussion in 'General Support' started by TrynaLearn, Mar 11, 2019.

  1. TrynaLearn

    TrynaLearn Member

    Joined:
    Jan 24, 2018
    Messages:
    72
    Likes Received:
    4
    Trophy Points:
    40
    Gender:
    Male
    Got this blaster. Got it running now I'm seeing a milky gray substance on bottom of the case and can't locate where it is coming from. And in Cant tell how much oil is in tyranny thru that little glass help please scared to ride it until I know where this is coming from
     
  2. Awk08

    Awk08 Administrator Staff Member Technician Forum Supporter

    Joined:
    Jan 30, 2009
    Messages:
    24,020
    Likes Received:
    2,086
    Trophy Points:
    175
    Occupation:
    Electrician/Contractor
    Location:
    Pa.
    hose connected to the breather nipple ?
    on kicker side near rear cylinder base nut, should be a nipple on case with a hose that runs up, across and to under the hood

    clutch cover bolts all present and tightened to spec ? 7.2 ft. lbs.

    best way to know whats in there is drain it and add 650ml of new 10w-30 oil for wet clutches
    I like mobile1-4T
     
  3. TrynaLearn

    TrynaLearn Member

    Joined:
    Jan 24, 2018
    Messages:
    72
    Likes Received:
    4
    Trophy Points:
    40
    Gender:
    Male
    Thanks awk08 but I found the culprit it's coming from behind the front sprocket is that a easy fix
     
    Awk08 likes this.
  4. Awk08

    Awk08 Administrator Staff Member Technician Forum Supporter

    Joined:
    Jan 30, 2009
    Messages:
    24,020
    Likes Received:
    2,086
    Trophy Points:
    175
    Occupation:
    Electrician/Contractor
    Location:
    Pa.
    you mean the output shaft seal behind the sprocket ? or chain whack has broken thru ?

    the seal is fairly easy, you'll need a new seal obviously, a seal puller or run 2 screws into it just enough to grab and pull it out by the screws, put electrical tape over the sharp edges of the shaft to keep the seal from tearing on them as you slide it on and into place, use the correct size deep socket or piece of PVC pipe to tap the seal in evenly, then remove tape and reinstall the gear/chain.
     
  5. TrynaLearn

    TrynaLearn Member

    Joined:
    Jan 24, 2018
    Messages:
    72
    Likes Received:
    4
    Trophy Points:
    40
    Gender:
    Male
    Do front sprocket face groove on or groove out? 20190312_163039.jpg 20190312_163039.jpg ho 20190312_163039.jpg 20190312_164120.jpg 20190312_164123.jpg
     
  6. Larry's Shee

    Larry's Shee Active Member

    Joined:
    May 23, 2009
    Messages:
    7,843
    Likes Received:
    686
    Trophy Points:
    149
    Occupation:
    Unemployed carpenter
    Location:
    Ortskaville, MI
    I would think that the markings would face out.
     

Share This Page