Need a running motor! Or a working complete bottom end.

Discussion in 'Northwest' started by ATVzFanatic, Jul 29, 2021.

  1. ATVzFanatic

    ATVzFanatic New Member

    Joined:
    Jul 28, 2021
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    17
    Gender:
    Male
    Bought a 01 blaster it’s all there but the motor wasn’t shifting properly so I split the cases. The piston is shot the cylinder has some deep grooves or scoring. And i have no idea why it wasn’t shifting everything looked fine. Only thing that I could think of was the shift forks are worn or bent slightly at this point I think I’d be better of buying a working motor or atleast a complete bottom end and buy a new top end rebuild kit. I’m in Wisconsin but willing to pay for shipping. I’m also brand new to the site so I hope I’m posting this right.
     
  2. Larry's Shee

    Larry's Shee Active Member Technician

    Joined:
    May 23, 2009
    Messages:
    8,928
    Likes Received:
    977
    Trophy Points:
    149
    Occupation:
    Unemployed carpenter
    Location:
    Ortskaville, MI
    We’re you trying to ride it and it wouldn’t shift?

    How good of a mechanic are you?
    If you do it yourself DO NOT use an egay/Amazon kit.
    Get a Clymers repair manual or use the PDF in the general repair section.

    Very few places I would trust to build an engine. Or sell a “running “ engine
     
  3. ATVzFanatic

    ATVzFanatic New Member

    Joined:
    Jul 28, 2021
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    17
    Gender:
    Male
    Yes Larry it would shift into first no problem but after that u would shift up and nothing it sounds like it shifted but u we’re ether in first still or neutral once in a while I’d find 3rd or 4th gear
     
  4. blasterBruce

    blasterBruce Member

    Joined:
    May 13, 2008
    Messages:
    2,361
    Likes Received:
    36
    Trophy Points:
    84
    Gender:
    Male
    Occupation:
    Mechanic/Technician
    Location:
    Griffin Ga
    I'm more than happy to help you repair your bottom end and get you back going, I have an engine here that a fella was having issues getting sealed up, turned out it had a few worn parts inside and Luckily I have spares here from damaged case bottom ends I've purchased over the years, Feel free to message me if interested in having yours repaired, Have one going back to ohio soon once parts get here lol
     
  5. SmokinAces623

    SmokinAces623 New Member

    Joined:
    Sep 7, 2021
    Messages:
    2
    Likes Received:
    1
    Trophy Points:
    4
    Gender:
    Male
    Do you have a good bottom end for sale? Not sure how to message you directly. Just joined today.
     
    blasterBruce likes this.
  6. blasterBruce

    blasterBruce Member

    Joined:
    May 13, 2008
    Messages:
    2,361
    Likes Received:
    36
    Trophy Points:
    84
    Gender:
    Male
    Occupation:
    Mechanic/Technician
    Location:
    Griffin Ga
    As a Matter of fact I have a bottom end I just went through and installed a low hour wiseco crank with new main bearings, the left side case had a crack from chain wack that has been repaired with epoxy, 600 shipped lower 48 paypal only. I will message you and we can go from there.
     

Share This Page