If ken did it it's probably a rechambered head. Which is way better than. A plain milled head.it will work with your piston and bottom end. Just check compression to make sure it was not rechambered for race gas. That would be a special request.you should be good to goWassup blaster forum. I have a quick question, I have a milled head. I wanted to know if it will work with stock bottom end and a wiseco piston. No overbore just stock 66. Thanks
Also it was machined by kenoconnor
If head was rechambered you will have higher compression already.if your that thin gasket.i would check squish and compression.or run regular thickness gaskets
