My 2000 Yamaha blaster was idling fine,there was a oil leak so I decided to take the engine out(turns out the it was just the gasket by the shifter shaft that cause leak).So when I put the engine back on it wouldn’t idle and was choppy on the gas,is this a premix problem or not tight screws? I only had the engine out for a couple of days and it only sat there,
IDLE HELP
- Thread starter Wali
- Start date
Did you leak test after fitting the carb?
Idle adjusting.
Set float level, make sure that all jets are clean and fuel flows freely from the float bowl drain
when the screw is cracked open.
Start with air screw 1.5 turns out.
Set idle screw so that it has some sort of idle. With TORS it is the big screw under seat on top of
unit. With no TORS is is the brass screw midway down carb body.
Warm up motor and then set idle screw for a faster idle, 2000rpm+
Adjust air screw either way to get the fastest idle.
Adjust air screw a little at a time leaving 10 secs or until the motor responds.
Re adjust idle screw for desired idle .
if the air screw ends up being more than 2 1/2 turns out the pi;]lot is too big.
if the air screw is less than 1/2 a turn out the pilot is too small
Idle adjusting.
Set float level, make sure that all jets are clean and fuel flows freely from the float bowl drain
when the screw is cracked open.
Start with air screw 1.5 turns out.
Set idle screw so that it has some sort of idle. With TORS it is the big screw under seat on top of
unit. With no TORS is is the brass screw midway down carb body.
Warm up motor and then set idle screw for a faster idle, 2000rpm+
Adjust air screw either way to get the fastest idle.
Adjust air screw a little at a time leaving 10 secs or until the motor responds.
Re adjust idle screw for desired idle .
if the air screw ends up being more than 2 1/2 turns out the pi;]lot is too big.
if the air screw is less than 1/2 a turn out the pilot is too small
it was idling fine before so i don’t know why it would need an air leak test if I didn’t mess with it
Similar threads
