I was cleaning my transmission after splitting my case. I flipped it upside down and sprayed brake cleaner to make sure there wasn’t any dirt or anything in the gears. A rod just fell out of the transmission. I think it’s a clutch push rod but I’m not too sure. I have bored out my cylinder and I’m ready to reassemble my engine. But I don’t know where this rod came from. I’m pretty dumb, I know.
Help with transmission
- Thread starter Fabio566
- Start date
Here is a picture of the rod and where I think it goes
Attachments
Yup
Guaranteed you lost the ball bearing that goes between the rod and the clutch adjuster in the pressure plate.
DO NOT use a BB, that’s a temporary emergency fix
There is a service manual pdf in the general section
Guaranteed you lost the ball bearing that goes between the rod and the clutch adjuster in the pressure plate.
DO NOT use a BB, that’s a temporary emergency fix
There is a service manual pdf in the general section
nope just found it on the floor. I guess I’m lucky. Do you know how to reassemble this?
Last edited:
Everything you need is in here https://www.blasterforum.com/thread...ervice-and-owner-manuals-free-download.17325/
Or get a Clymers repair manual
Easier than trying to explain.
Biggest thing is make sure clutch arm is pulled towards the back
Or get a Clymers repair manual
Easier than trying to explain.
Biggest thing is make sure clutch arm is pulled towards the back
