GOT TO RIDE TODAY FINALLY!!!!!!!

gizzy2014

Rippin' Hard
Jul 22, 2012
1,468
39
85
dickinson ND
still a 8-12 inches of snow on the ground but its hard enought that we can ride on top for the most part, i had my 85 out today herpderp had the blaster going to, and a friend had his 04 crf250 riding

i missed the smell of 2-stoke so much

on the down-side broke a piece of my front fender off flipping it over forward.
 
I drove my truck to work and back...does that count?
glad some members are getting out and riding. I have at least 2 months to go before I can get out and ride.
 
I definitely need an extended swinger lol

My LRD didnt match up to the porting so well. With the DMC its crazy!

There is no way to keep the front end down. I bet i could pop it up in 6th if i wanted to
 
I could feel the porting power, and then the pipe power at separate times

With the DMC i have a slight studder in 1st and 2nd with mid to low rpms. I plan to dial this in perfectly while i still have a legal road to ride on....

Richen the needle up a slot. I did following Blaaster's advise, and It took that out of it.
 
DMC recommends the stock needle on the lowest clip!

I have tried a richer needle with no luck, the stock one works just fine.
 
Last edited:
well i rode today by myself and had the gopro on my helmet for a vid for you guys...... but the go pro angle was done.... and you cant see anything, so myabe tomorrow or something, or maybe later my friend might bring his 85 over.