Cylinder Head

Discussion in 'Engine' started by MarkRS4, Jun 26, 2020.

  1. MarkRS4

    MarkRS4 New Member

    Joined:
    Jun 18, 2020
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    7
    Gender:
    Male
    Hi Guys.

    Im from the UK.

    I’ve bought 2 blasters that need work and im currently doing the cylinder head on one of them.

    I could t get a head from anywhere so ordered the china variant from ebay. The questions i have are where can i get head threaded rod / exhaust Threaded rods?

    and the oem head has a locating/ circle pin in the corner which the china one doesn't ... is that needed on the new head?


    Any help would be appreciated

    mark
     
  2. Larry's Shee

    Larry's Shee Active Member

    Joined:
    May 23, 2009
    Messages:
    8,520
    Likes Received:
    877
    Trophy Points:
    149
    Occupation:
    Unemployed carpenter
    Location:
    Ortskaville, MI
    Chi-NA strikes again!!

    First, what is wrong with old heads?

    Probably not the best scenario but unless you’re going for a high horse build it will be OK
     
  3. Slydog

    Slydog Member Technician

    Joined:
    Nov 3, 2019
    Messages:
    1,324
    Likes Received:
    216
    Trophy Points:
    99
    Gender:
    Male
    Occupation:
    Diesel mech
    Location:
    Florida
    How's it going over in the uk?
    There is no dowel/ locating pin used On the blaster head.
    The cylinder head will need studs.washers and nuts. Which i think are hardened.
     

Share This Page