clutch adjustment

Discussion in 'Engine' started by motomadness, Aug 3, 2019.

  1. motomadness

    motomadness New Member

    Joined:
    Feb 6, 2012
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    17
    Occupation:
    truck driver
    Location:
    sioux falls s.d
    When i replaced the clutch discs and installed the pressure plate when I try to make the adjustment using the center screw It seems like there is not enough bolt to tighten properly. What am I doing wrong??
     
  2. Awk08

    Awk08 Administrator Staff Member Technician

    Joined:
    Jan 30, 2009
    Messages:
    24,170
    Likes Received:
    2,144
    Trophy Points:
    175
    Occupation:
    Electrician/Contractor
    Location:
    Pa.
    Is the ball bearing in there between the 2 rods ?
    sounds like it might have rolled out or got lost while you worked on it


    are you adjusting it with the cable off the actuator and aligning the pointer to notch ?

    [​IMG]
     
  3. motomadness

    motomadness New Member

    Joined:
    Feb 6, 2012
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    17
    Occupation:
    truck driver
    Location:
    sioux falls s.d
    Yes the cable is off the actuator and the ball bearing is between the two rods.
     
  4. brian3127

    brian3127 New Member

    Joined:
    Jun 22, 2019
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    22
    Gender:
    Male
    you dont have your plates in correctly. there is a washer spring the diameter of the inside basket that has to be in right. there is one clutch plate that has a bigger inside diameter than the other plates that one has to be on the outside of the spring washer. i believe it goes clutch plate metal disc, spring washer and the bigger inside diameter clutch plate. the metal disc, clutch plate ect.
     
  5. Larry's Shee

    Larry's Shee Active Member

    Joined:
    May 23, 2009
    Messages:
    8,117
    Likes Received:
    743
    Trophy Points:
    149
    Occupation:
    Unemployed carpenter
    Location:
    Ortskaville, MI
    Did you line up the marks on basket and pressure plate?
     

Share This Page