Can't figure this out....?

BlkCeasar

Member
Feb 27, 2019
10
1
40
35
Ft. Lauderdale
So I got my bike rebuilt top & bottom with vito's position, crank & clutches. Now I'm having a gas flow issue where it's only cranking when I pull the choke. When i release it the bike will run until the gas is out the carb. What suggestions you got for me?
 
leakdown tested ?
check for good steady fuel flow to carb, clean or replace petcock screens or whole unit if needed.
remove any fuel filters if added.

clean your carb, and set/check float height and airscrew.....

https://www.blasterforum.com/threads/how-to-clean-your-carbureutor.254/

https://www.blasterforum.com/threads/float-heights-and-how-to-adjust-them.50565/

https://www.blasterforum.com/threads/adjusting-your-airscrew-pilot-jet.51060/

check your reeds while you're in there..... no cracks, chips, gaps, or broken petals