Blaster won’t start

Discussion in 'General Support' started by lucknuts, May 12, 2019.

  1. lucknuts

    lucknuts Member

    Joined:
    Apr 27, 2019
    Messages:
    11
    Likes Received:
    3
    Trophy Points:
    39
    Gender:
    Male
    Issue before ripping into it was that it was bogging down and lots of white smoke. Needed to be gone over anyways since it hasn’t for a year. Started first kick all the time previously.

    Past week...
    I Replaced all gaskets and crank and stator side seals.
    Compression is 110
    New boysen 630 power reeds
    New caltric ignition coil
    Br8es spark plug
    Piston is fine
    Carb had issue with leaking, had a spare bowl that fit fine on the mikuni, leak was the bottom bowl screw.

    Not sure where to start. I have spark, I have compression...

    Something to do with carb, or flooded bottom maybe...looking more into it tomorrow.

    Any suggestions. Thanks!
     
    Last edited: May 13, 2019
  2. Larry's Shee

    Larry's Shee Active Member

    Joined:
    May 23, 2009
    Messages:
    7,994
    Likes Received:
    723
    Trophy Points:
    149
    Occupation:
    Unemployed carpenter
    Location:
    Ortskaville, MI
    Start with a leak down test. White smoke is indication of leaking crank seal . Replace both.
     
    lucknuts likes this.
  3. lucknuts

    lucknuts Member

    Joined:
    Apr 27, 2019
    Messages:
    11
    Likes Received:
    3
    Trophy Points:
    39
    Gender:
    Male
    leak down tester is on way. Hoping to do that shortly.

    Seals both sides are new
     

Share This Page