Another KOR Beauty

[82cutty]

Got my KOR top end back from Ken on Wednesday . Came out great !! Ken did an awesome job . Got it on Wednesday night...leak test good . Did my 4 heat cycles today...Runs awesome . Sounds a lot different than my other stock cylinder . Cant wait to take it for a ride later

 

[Awk08]

ride report is a must

 

[joeak47]

What he said /\ /\ /\

 

[82cutty]

Just got back from a good 45 min. ride .Wow is all I can say . It's pretty crazy compared to my stock cylinder . Pulls so much more and sounds completely different . I need to adjust my air screw and maybe move the needle . It's in the stock settings now . It's a little blubbery at 1/4-1/3 throttle . But then kicks your a$$ . Didn't go past 3/4 throttle . Can't wait to break her in and open her up

 

[Blaaster]

You should adjust the idle screw and air screw settings before you ride!

Seldom does a needle have to be used on any other clip than the middle one.

It is possible to do an 1/2 throttle plug chop to confirm the needle setting!

 

[82cutty]

Had to take it for a ride ...make the adjustments later

 

[79 bronco]

omg blaster porn! Nice!

 

[82cutty]

Yes indeed... Had to fire everyone up lol

 

[bummer981]

Just wait till you can crack it wide open. This is what I look like after I get off my KOR Ported Blaster.

 

[82cutty]

I know... I hit 4th gear and gave her 3/4 throttle and started laughing . I was like oh $hit lol