2001 raptor 660

Discussion in 'Yamaha' started by moefie35, Jun 22, 2021.

  1. moefie35

    moefie35 Member

    Joined:
    Jun 22, 2017
    Messages:
    88
    Likes Received:
    8
    Trophy Points:
    56
    Gender:
    Male
    Any knowledgeable mechanics in here that knows a lil about the raptor660
     
  2. Larry's Shee

    Larry's Shee Active Member Technician

    Joined:
    May 23, 2009
    Messages:
    8,875
    Likes Received:
    968
    Trophy Points:
    149
    Occupation:
    Unemployed carpenter
    Location:
    Ortskaville, MI
    Try asking a more specific question.
     
    moefie35 likes this.
  3. moefie35

    moefie35 Member

    Joined:
    Jun 22, 2017
    Messages:
    88
    Likes Received:
    8
    Trophy Points:
    56
    Gender:
    Male
    this is where I'm hearing squealing from on my raptor 660 it's not brakes just checked those is there anything else I need to check 20210707_122527.jpg
     
  4. moefie35

    moefie35 Member

    Joined:
    Jun 22, 2017
    Messages:
    88
    Likes Received:
    8
    Trophy Points:
    56
    Gender:
    Male
    And why are there 2 bolts on the right back side one was loose couldn't screw all the way on 20210707_122821.jpg
     
  5. blasterBruce

    blasterBruce Member

    Joined:
    May 13, 2008
    Messages:
    2,338
    Likes Received:
    29
    Trophy Points:
    84
    Location:
    Griffin Ga
    most likely the noise is your carrier/axle bearings, those 2 large nuts are lock nuts, they should both be tight otherwise your sprocket could rock around and wear the axle/hub
     
    moefie35 likes this.
  6. moefie35

    moefie35 Member

    Joined:
    Jun 22, 2017
    Messages:
    88
    Likes Received:
    8
    Trophy Points:
    56
    Gender:
    Male
    Thanks bud
     
    blasterBruce likes this.
  7. blasterBruce

    blasterBruce Member

    Joined:
    May 13, 2008
    Messages:
    2,338
    Likes Received:
    29
    Trophy Points:
    84
    Location:
    Griffin Ga
    No problem boss
     
  8. Larry's Shee

    Larry's Shee Active Member Technician

    Joined:
    May 23, 2009
    Messages:
    8,875
    Likes Received:
    968
    Trophy Points:
    149
    Occupation:
    Unemployed carpenter
    Location:
    Ortskaville, MI
    Most likely your axle bearings are shot
     

Share This Page