04 Blaster Wiring

Discussion in 'Yamaha' started by DieselFreak, Apr 1, 2018.

  1. DieselFreak

    DieselFreak New Member

    Joined:
    Apr 1, 2018
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    i got an 04 Blaster I need to figure out exactly what wires as a bare minimum I need for the bike to run, I’m pretty sure I have a cdi that crapped out, but before hand it would run sometimes and sometimes not, I wiggles wires around for the tors and bike ran awesome then went to running like crap, I deleted the tors, and park brake switch, those circuits should be okay if left open am I understanding that correctly?
     
  2. Blaaster

    Blaaster Moderator Staff Member Technician Forum Supporter

    Joined:
    Jul 18, 2011
    Messages:
    15,363
    Likes Received:
    1,081
    Trophy Points:
    165
    Gender:
    Male
    Occupation:
    Pensioner
    Location:
    eastern australia
  3. DieselFreak

    DieselFreak New Member

    Joined:
    Apr 1, 2018
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    Thanks ive seen that, it didn’t help me out very much did he connect the two yellow/black wires together or did he connect yellow/black and black/white together? Also in my question I was also asking about what wires absolutely have to be there and which ones can go, I would rathe clip wires back at cdi box
     
  4. Larry's Shee

    Larry's Shee Active Member

    Joined:
    May 23, 2009
    Messages:
    7,381
    Likes Received:
    600
    Trophy Points:
    149
    Occupation:
    Unemployed carpenter
    Location:
    Ortskaville, MI
    After you do the TORS check both switches
     

Share This Page